Germanjet magnetostriction Displacement sensor For the smooth use of our own products, we usually connect the standard 1m 6-core cable according to the requirements of our own manufacturer. The wiring method is shown in the following figure:
When we leave the factory, we can change it into 4-wire system according to the requirements of customers, which is the way of power isolation. Two wires are power lines and two wires are current output lines. If the customer has requirements for accuracy, linearity and stability, and there is an independent power supply, the Displacement sensor The overall performance will be greatly improved.
However, customers often no longer supply power independently on site, but directly supply power by PLC. Therefore, the current 3-wire system is required. The method is to short-circuit the blue cable and the green cable, and connect them to the negative pole of the power supply (or PLC).
Don't underestimate the difference between line 3 and line 4. The main reason is that line 4 is used in high requirements and line 3 is used in occasions with low environmental requirements. Customers can coordinate with our company according to the actual use.
As long as it is not voltage or current output, it can be said that it belongs to digital output. Generally, digital output needs an IP address. The displacement sensor of DMZ has obvious identification on the outer package of the product. Please do not throw away the outer package before recording the IP address when receiving the goods, so as to avoid affecting the normal production and use